TAT

Instruction movies of refill ink for TAT stampers.
If the video will not play, click on the link below to watch.

TAT STAMPERS

XQT-6C / 11C

  1. Remove cap and place face down.
  2. Hold stamp handle firmly and pull out die holder from handle.
  3. Place die holder on top of removed cap with impression die facing down. Hold die holder firmly and remove top plug.
  4. Place recommended number of drops of ink into the opening.

XQT-30C

  1. Screw off cap and hold handle vertically. Use bottom-side of cap to remove die holder. Insert bottom of cap to die holder and turn handle counter-clockwise towards ‘open’ to remove die holder.
  2. Place recommended number of drops of ink into the opening.

XQT-16C / 20C

  1. Remove the holder and insert into bottom of cap.
  2. Place drops of ink into the opening.

XQT-1342C

  1. Remove the holder and take out the caps.
  2. Place drops of ink into the openings.

CLASSIX

CGFQ-E6-U / CGFQ-E11-U

  1. Turn the holder to the left and remove.
  2. Push the slide all the way in, and remove the cartridge. At this time, turn the grip over and place it upside down.
  3. Refill the ink 1 drop at a time to the ink absorber inside the cartridge. Refill until the entire surface of the ink absorber is covered as far as possible.
  4. After refilling the ink, check the cartridge orientation while mounting the grip, and then extend the slide and mount the holder.